Microplastic accumulation in sewer sediments and its potential entering the environment via combined sewer overflows: a study case in Paris.

During wet weather events, combined sewer overflows (CSOs) transfer large amount of particulate matter and associated pollutants into surrounding water bodies, thereby deteriorating the recipients' ecological health. Resuspension of sewer sediments during these events contributes significantly to pollution level of these discharges. However, how much this in-sewer process contributes to CSOs' quality regarding microplastic (MP) pollution is little known. Therefore, an investigation on sewer deposits inside the Parisian combined sewer network was carried out. The study found high MP concentrations stored in this matrix, ranging from 5 × 103 to 178 × 103 particle/kg dry weight. Polymer composition is similar to what found in raw wastewater, containing a high proportion of polyethylene and polypropylene. Thus, the results indicated the persistence of MPs in sewer network during transport during dry weather periods to treatment facilities. Once resuspension of sewer deposits happens, MPs can be released into water flow and get discharged along with CSOs. This highlights another potential pathway of MPs into freshwater environment.

COVID lockdown significantly impacted microplastic bulk atmospheric deposition rates.

Here, microplastic atmospheric deposition data collected at an urban site during the French national lockdown of spring 2020 is compared to deposition data from the same site in a period of normal activity. Bulk atmospheric deposition was collected on the vegetated roof of a suburban campus from the Greater Paris and analysed for microplastics using a micro-FTIR imaging methodology. Significantly lower deposition rates were measured overall during the lockdown period (median 5.4 MP m-2.d-1) than in a period of normal activity in spring 2021 (median of 29.2 MP m-2.d-1). This difference is however not observed for the smallest microplastic size class. The dominant polymers identified were PP, followed by PE and PS. Precipitation alone could not explain the differences between the two campaigns, and it is suggested that the temporary drop in human activity during lockdown is the primary cause of the reduced deposition rates. This study provides novel insight on the immediate impact of human activities on atmospheric microplastics, thus enhancing the global understanding on this topic.

Microplastic and microfiber fluxes in the Seine River: Flood events versus dry periods.

Studies on the influence of hydrodynamic conditions on anthropogenic microfiber (MF) and microplastic (MP) distributions in freshwater environments are sparse. In this study, we evaluated the influence of urbanisation gradient on the spatial variability of MFs and MPs. Temporal variability was also assessed by comparing the concentrations and fluxes of MFs and MPs under low flow conditions with those during the January-February 2018 flood event. For each period, Seine river water was collected upstream and downstream of Greater Paris and filtered through an 80 µm net at three different sampling sites. MFs were counted using a stereomicroscope, while MPs were analysed using micro-Fourier transform infrared spectroscopy coupled with siMPle analysis software. The highest concentrations of MFs and MPs were reported at the furthest downstream sites during both periods. However, high water flowrates and urbanisation gradient did not significantly impact MF and MP concentrations, sizes, or polymer distributions. The median MF and MP concentrations were 2.6 and 15.5 items/L and their interquartile ranges were 1.6 and 4.9 items/L (n = 10), respectively, illustrating relatively stable concentrations in spite of the urbanisation gradient and variations in the flowrate. In contrast to the concentration, size, and polymer distribution characteristics, MP mass fluxes were strongly affected by river flow. MF and MP fluxes show increases in the number and mass of particles from upstream to downstream. The downstream site presents high MP mass fluxes, which range between 924 and 1675 tonnes/year. These results may indicate significant MP inputs from the Paris Megacity through wastewater treatment plant effluents and untreated stormwater. The January-February 2018 flood event, which represented 14.5% of the year (in terms of time), contributed 40% of the yearly MP mass fluxes. Thus, flood events contribute strongly to MP fluxes.

Microplastics and microfibers in urban runoff from a suburban catchment of Greater Paris.

Microplastics (MPs) and microfibers (MFs) in stormwater have been poorly investigated. Data on their intra and inter rain events variability over time are still sparse. For the first time, the variability of microlitter concentrations in stormwater has been studied. MF and MP concentrations were investigated in stormwater runoff at the outlet of the suburban catchment at Sucy-en-Brie (a suburb of Paris, France), during four rain events. Median MF and MP concentrations were 1.9 and 29 items/L, with an interquartile range of 2.3 and 36 items/L, respectively (N = 18). A different pattern was observed between MFs and MPs. While no relationship or trends were observed for MFs, the highest MP concentrations were observed before the flow rate peak of the rain events. This could indicate a difference in the behaviour between MFs and MPs. We estimated the median MP mass concentration to be 56 µg/L with an interquartile range of 194 µg/L, whereas the mass concentration of macroplastics was estimated to be 31 µg/L with an interquartile range of 22 µg/L at the same sampling site, in a previous study. For this sampling site, MPs and macroplastics have the same order of magnitude. This study may have strong implications on microplastic assessment in urban waters.

A microfluidic chip enables fast analysis of water microplastics by optical spectroscopy.

Microplastics contaminating drinking water is a growing issue that has been the focus of a few recent studies, where a major bottleneck is the time-consuming analysis. In this work, a micro-optofluidic platform is proposed for fast quantification of microplastic particles, the identification of their chemical nature and size, especially in the 1-100 µm size range. Micro-reservoirs ahead of micro-filters are designed to accumulate all trapped solid particles in an ultra-compact area, which enables fast imaging and optical spectroscopy to determine the plastic nature and type. Furthermore, passive size sorting is implemented for splitting the particles according to their size range in different reservoirs. Besides, flow cytometry is used as a reference method for retrieving the size distribution of samples, where chemical nature information is lost. The proof of concept of the micro-optofluidic platform is validated using model samples where standard plastic particles of different size and chemical nature are mixed.

Identification and quantification of macro- and microplastics on an agricultural farmland.

Microplastic contamination of aquatic ecosystems is a high priority research topic, whereas the issue on terrestrial ecosystems has been widely neglected. At the same time, terrestrial ecosystems under human influence, such as agroecosystems, are likely to be contaminated by plastic debris. However, the extent of this contamination has not been determined at present. Via Fourier transform infrared (FTIR) analysis, we quantified for the first time the macro- and microplastic contamination on an agricultural farmland in southeast Germany. We found 206 macroplastic pieces per hectare and 0.34 ± 0.36 microplastic particles per kilogram dry weight of soil. In general, polyethylene was the most common polymer type, followed by polystyrene and polypropylene. Films and fragments were the dominating categories found for microplastics, whereas predominantly films were found for macroplastics. Since we intentionally chose a study site where microplastic-containing fertilizers and agricultural plastic applications were never used, our findings report on plastic contamination on a site which only receives conventional agricultural treatment. However, the contamination is probably higher in areas where agricultural plastic applications, like greenhouses, mulch, or silage films, or plastic-containing fertilizers (sewage sludge, biowaste composts) are applied. Hence, further research on the extent of this contamination is needed with special regard to different cultivation practices.

Macroplastic and microplastic contamination assessment of a tropical river (Saigon River, Vietnam) transversed by a developing megacity.

Both macroplastic and microplastic contamination levels were assessed for the first time in a tropical river estuary system, i.e. the Saigon River, that traverses a developing South East Asian megacity, i.e. Ho Chi Minh City, Vietnam. The analysis of floating debris collected daily on the Nhieu Loc - Thi Nghe canal by the municipal waste management service shows that the plastic mass percentage represents 11-43%, and the land-based plastic debris entering the river was estimated from 0.96 to 19.91 g inhabitant-1 d-1, namely 350 to 7270 g inhabitant-1 yr-1. Microplastics were assessed in the Saigon River and in four urban canals by sampling bulk water for anthropogenic fiber analysis and 300 µm mesh size plankton net exposition for fragment analysis. Fibers and fragments are highly concentrated in this system, respectively 172,000 to 519,000 items m-3 and 10 to 223 items m-3. They were found in various colors and shapes with smallest size and surface classes being predominant. The macroplastics and fragments were mainly made of polyethylene and polypropylene while the anthropogenic fibers were mainly made of polyester. The relation between macroplastic and microplastic concentrations, waste management, population density and water treatment are further discussed.

Synthetic and non-synthetic anthropogenic fibers in a river under the impact of Paris Megacity: Sampling methodological aspects and flux estimations.

Processed fibers are highly present in our daily life and can be either natural, artificial (regenerated cellulose) and synthetic (made with petrochemicals). Their widespread use lead inevitably to a high contamination of environment. Previous studies focus on plastic particles regardless of their type or shape as long as they are comprised between 330µm and 5mm. On the contrary, this study focuses exclusively on fibers using a smaller mesh size net (80µm) to sample freshwater. Moreover, all processed organic fibers are considered, irrespective to their nature. First, the short term temporal variability of the fibers in the environment was assessed. While exposing the sampling net during 1min a coefficient of variation of approx. 45% (with n=6) was determined. It was of only 26% (n=6) when the exposure was of 3min. The assessment of the distribution through the section showed a possible difference in concentrations between the middle of the water surface and the river banks which could be attributed to the intense river traffic within the Paris Megacity. The vertical variability seems negligible as turbulence and current conditions homogenize the distribution of the fibers. A monthly monitoring showed concentrations of 100.6±99.9fibers·m-3 in the Marne River and of: 48.5±98.5, 27.9±26.3, 27.9±40.3 and 22.1±25.3fibers·m-3 from the upstream to downstream points in the Seine River. Once these concentrations are converted into fluxes, it seems that the impact generated by the Paris Megacity cannot be distinguished. Investigations on the role of sedimentation and deposition on the banks are required. This study helped fill some major knowledge gaps regarding the fibers in rivers, their sampling, occurrence, spatial-temporal distribution and fluxes. It is encouraged that future studies include both synthetic and none synthetic fibers.

A first overview of textile fibers, including microplastics, in indoor and outdoor environments.

Studies about microplastics in various environments highlighted the ubiquity of anthropogenic fibers. As a follow-up of a recent study that emphasized the presence of man-made fibers in atmospheric fallout, this study is the first one to investigate fibers in indoor and outdoor air. Three different indoor sites were considered: two private apartments and one office. In parallel, the outdoor air was sampled in one site. The deposition rate of the fibers and their concentration in settled dust collected from vacuum cleaner bags were also estimated. Overall, indoor concentrations ranged between 1.0 and 60.0 fibers/m3. Outdoor concentrations are significantly lower as they range between 0.3 and 1.5 fibers/m3. The deposition rate of the fibers in indoor environments is between 1586 and 11,130 fibers/day/m2 leading to an accumulation of fibers in settled dust (190-670 fibers/mg). Regarding fiber type, 67% of the analyzed fibers in indoor environments are made of natural material, primarily cellulosic, while the remaining 33% fibers contain petrochemicals with polypropylene being predominant. Such fibers are observed in marine and continental studies dealing with microplastics. The observed fibers are supposedly too large to be inhaled but the exposure may occur through dust ingestion, particularly for young children.

Synthetic fibers in atmospheric fallout: A source of microplastics in the environment?

Sources, pathways and reservoirs of microplastics, plastic particles smaller than 5mm, remain poorly documented in an urban context. While some studies pointed out wastewater treatment plants as a potential pathway of microplastics, none have focused on the atmospheric compartment. In this work, the atmospheric fallout of microplastics was investigated in two different urban and sub-urban sites. Microplastics were collected continuously with a stainless steel funnel. Samples were then filtered and observed with a stereomicroscope. Fibers accounted for almost all the microplastics collected. An atmospheric fallout between 2 and 355 particles/m(2)/day was highlighted. Registered fluxes were systematically higher at the urban than at the sub-urban site. Chemical characterization allowed to estimate at 29% the proportion of these fibers being all synthetic (made with petrochemicals), or a mixture of natural and synthetic material. Extrapolation using weight and volume estimates of the collected fibers, allowed a rough estimation showing that between 3 and 10 tons of fibers are deposited by atmospheric fallout at the scale of the Parisian agglomeration every year (2500 km(2)). These results could serve the scientific community working on the different sources of microplastic in both continental and marine environments.

Assessment of floating plastic debris in surface water along the Seine River.

This study is intended to examine the quality and quantity of floating plastic debris in the River Seine through use of an extensive regional network of floating debris-retention booms; it is one of the first attempts to provide reliable information on such debris at a large regional scale. Plastic debris represented between 0.8% and 5.1% of total debris collected by weight. A significant proportion consisted of food wrappers/containers and plastic cutlery, probably originating from voluntary or involuntary dumping, urban discharges and surface runoff. Most plastic items are made of polypropylene, polyethylene and, to a lesser extent, polyethylene terephthalate. By extrapolation, some 27 tons of floating plastic debris are intercepted annually by this network; corresponding to 2.3 g per Parisian inhabitant per year. Such data could serve to provide a first evaluation of floating plastic inputs conveyed by rivers.